So we are doing away with timing seeing our supertimer isn't quite designed for space derby and we have tried a few different ways to trigger the sensors and have had really no consistency. We still would like to make it competitive but fun most of all. So here is what we are doing.
Going to a point system based on distance. We are also having an 8 lane race because the kids just want to see their rockets race and 8 rockets at the same time is a spectacle. We have a plan it is not at all equal for a competitive race but I think it will satisfy both fun and competitive natures.
So now to the question. We will have around 50-60 entries I am guessing. I would like a method that I can use that will allow 8 lanes with not everybody racing in all 8 through the entire race seeing we will be doing only 4 phases. I am guessing we could schedule more and just stop it early if needed due to time constraints. So if the method will only let you schedule 8 phases then so be it. We will see how it goes. I would like to make sure that the match-ups are mixed up. I need to get the schedule ahead of time for all the phases so the pit crew can start getting the rockets ready for the next phase while we are finishing the other one. I am not up on all the charts and how they work. I would like to use GPRM to create the schedule unless a spread sheet can do the same thing. Again I am not a math wiz or even a computer one. We will use a spreadsheet to keep track of the points and the ones with the highest total will be determined the winners.
So any suggestions on a method or how to generate a schedule based on what I have told you?
Give points according to finish order, 8 pts to 8th place, 1 point to 1st place.
LOW scores win, like in golf.
Found this to be easier, no transposition of who got 4th and gets 5 points etc...
- Stan Pope
- Pine Head Legend
- Posts: 6888
- Joined: Sat Jul 05, 2003 7:01 pm
- Location: Morton, Illinois
1. an equal number of runs by each competitor, and
2. an equitable mix of opponents.
PWD needs an equal number of runs in each lane. Space Derby may not. (Dunno if this latter assertion is true or not, but is assumed in the question.)
Stearns in the most incremental way of satisfying #1 and 2 that I know of, since it creates schedules in increments of 1 heat per racer. I dunno if Stearns is among the options in GPRM, but software to create the schedules has been freely available for years.
"If it's not for the boys, it's for the birds!"
- Site Admin
- Posts: 4677
- Joined: Fri Jun 20, 2003 12:46 am
- Location: Highlands Ranch, CO
There can easily be lane differences in a Space Derby track (difference in line tension, frays in the line, levelness of each line, etc.)Stan Pope wrote:PWD needs an equal number of runs in each lane. Space Derby may not. (Dunno if this latter assertion is true or not, but is assumed in the question.)
Nope. With GPRM someone can build a custom schedule or run a Dynamic schedule. With Dynamic scheduling, each run down the track for everyone is a Phase. You can do as many phases as you wish. Matchups in Phase 2+ are based on results from all previous phases. Of course, as with any scheduling method, Dynamic scheduling has its pros and cons that should be reviewed before using.Stan Pope wrote:I dunno if Stearns is among the options in GPRM, but software to create the schedules has been freely available for years.
Awana Grand Prix and Pinewood Derby racing - Where a child, an adult and a small block of wood combine for a lot of fun and memories.
We are compromising on full equality for hopefully the fun/wow factor.
I am just looking for an easy way to generate a schedule.