I wonder if one could reduce the diameter of the outer inch of a typical drill bit by 0.001 or 0.002" using emery cloth. The cloth might tend to "reach around" the tip of the bit, though, and dull / ruin the cutting face of the bit. Anybody try this before with satisfactory results?Scubersteve wrote:well, I bought cheapo 3/32 drill bits in a two pack and they are never quite the same size, so i drill a test hole with each one and one of them was a perfect snug fit... and it was actually a straight bit! Almost unheard of in cheapy bits I know. Got lucky.
Wheel Installation Q's
- Stan Pope
- Pine Head Legend
- Posts: 6856
- Joined: Sat Jul 05, 2003 7:01 pm
- Location: Morton, Illinois
- Contact:
Re: Wheel Installation Q's
Stan
"If it's not for the boys, it's for the birds!"
"If it's not for the boys, it's for the birds!"