- Master Pine Head
- Posts: 556
- Joined: Wed Dec 26, 2007 5:25 pm
- Location: Dr. Phillips, Florida
What are some opinions of upgrade paths for this hardware?
can a K series chip be installed on that board without modification?
will such an addition give the capabilities of that K series chip?
it does not appear that a starting gate trigger was contemplated with this version - other than the switch itself, any possibility of this board being upgraded for accepting that component?
Once again, great to be amongst the Derby Gurus..
- Site Admin
- Posts: 4706
- Joined: Fri Jun 20, 2003 12:46 am
- Location: Highlands Ranch, CO
http://www.microwizard.com/k1page.htmlUpgrading the older P1 timers (PSU) will cost $ 75.00 because we have to physically retrofit the timer.
Another option would be to tie the sensors and start switch of that timer into an Arduino board. See http://www.derbytalk.com/viewtopic.php?f=5&t=6216
Awana Grand Prix and Pinewood Derby racing - Where a child, an adult and a small block of wood combine for a lot of fun and memories.