How Speedster builds a car

Topics not relating to derbies, regattas or cubmobile races.
Post Reply
Speedster
Pine Head Legend
Pine Head Legend
Posts: 1847
Joined: Sat Feb 18, 2012 2:48 pm
Location: Toledo, Ohio

How Speedster builds a car

Post by Speedster » Thu Feb 13, 2020 6:33 pm

I finished a simple wedge car today for Amy, the lady from The Toledo Lucas County Public Library who is in charge of what books are put in the library. The library has removed an old book that talked about the 1999 wheel molds and will now have Troy Thorne's 2013 Edition of, "Build a Winning Pinewood Derby car." That happens to be my favorite book and I always have 10 of them in stock.

This is the car I built and the way I build all my cars.

A slim wedge, 3 wheel rail rider, COG 1" in front of rear axle slot, 3 wheels with less then .003 out of round, BSA axles prepped from Maximum Velocity, Novus 2 polish for bores, Liquid Glass for bores, Hob-E-Lube graphite for lube. I used 3/8" lead rod for weight in this particular car. I often use 3/8" tungsten cylinders. I bend the nails for 3 wheels 1 1/2 degrees. I use the right front wheel for the dfw. The left rear wheel gets spaced .030 and the right rear wheel gets spaced .060. The dfw gets spaced 030. after the test board. Car is set to drift 2" in 4'. After running against the timer the car drifts 2" in 3'. I glue in the axles with Loctite Super Glue Gel. I know what you're going to say but I do it anyhow. I do not narrow the body of the car behind the dfw. The right rear wheel will stay off the rail by about 1/16" when running down a Best track. That's my build and it has been very successful racing under the Scout Commodore Perry District rules.

I know there has been a lot of talk about bending, not bending, rear axles. Here's my opinion. With a bent axle you have absolute control on how those rear wheels are going to perform. If you simply can't bend them you can buy them from Maximum Velocity. You can buy all 1 1/2 degree bends if you prefer. You can also buy preferred numbered wheels.

Best Wishes in your building and racing these little wooden cars.



Eagle
Pine Head
Pine Head
Posts: 96
Joined: Mon Sep 24, 2018 5:03 pm
Location: Fresno, CA

Re: How Speedster builds a car

Post by Eagle » Thu Feb 13, 2020 7:47 pm

Hope to see one of your simple wedge cars running at http://www.TheWestCoastGrandPrix.com
Would love to race one of your rigs as well!!



Post Reply